Autocad 3D and 2D Practice Activities | Circle

Please download to get full document.

View again

of 19
All materials on our website are shared by users. If you have any questions about copyright issues, please report us to resolve them. We are always happy to assist you.
Information Report
Category:

Documents

Published:

Views: 5 | Pages: 19

Extension: PDF | Download: 0

Share
Description
Autocad 3D and 2D Practice Activities
Tags
Transcript
  Figure 1. To make this object, notice the absolute coordinate location of the smaller circle (4,4.5) which is where you are going to start with. nd the rest of the object follows with it.Figure !. This object is made with the ad antage of the direct distance entry command to first make the #erimeter (first without the cur es). The cur es in the sides can be made by using the fillet   or circle-ttr command then trim . www.jntuworld.com www.jntuworld.com www.jwjobs.net   Figure $. gain notice the absolute coordinate location of the line in 1, $ and the #oint in 5,% which is where the rest of the drawing follows.Figure 4. This object again has absolute coordinates to follow. This is made through circles-2P , lines , and ars  (start&center&radius).Figure 5. To make this object, start with the line , then the arcs . The center of the arc in 45' is the end#oint of the location 1.5.Figure . This drawing again has absolute coordinate locations to follow. The triangle is made by following those commands gi en in numbered order. To circle inside the triangle is made through cicle-ttr command. www.jntuworld.com www.jntuworld.com www.jwjobs.net   Figure %. Though this object can be made through lines and arcs, the objecti e is to make this one using #olylines wherein the lines and arcs are connected.Figure *. This object starts with the smaller circles with the diameter or .5 and the rest follows.  circle-ttr command is more useful than using arc  to make the cur es. www.jntuworld.com www.jntuworld.com www.jwjobs.net   Figure +. This object is almost similar to figure + which also starts with the smaller circles. gain a cicle-ttr command is used here than arcs  to make the cur es. To co#y the arc inside or outside at a different radius, the offset   command could be useful.Figure 1. n this objects the direct distance entry could be useful to make the #erimeter. For the cur es on the edge, fillet   command could also be used. -elati e rectangular entry with snap-from  command could locate the circles center. To make the dash&dot center line you need to load the line in the linetype  bo/. www.jntuworld.com www.jntuworld.com www.jwjobs.net 
We Need Your Support
Thank you for visiting our website and your interest in our free products and services. We are nonprofit website to share and download documents. To the running of this website, we need your help to support us.

Thanks to everyone for your continued support.

No, Thanks
SAVE OUR EARTH

We need your sign to support Project to invent "SMART AND CONTROLLABLE REFLECTIVE BALLOONS" to cover the Sun and Save Our Earth.

More details...

Sign Now!

We are very appreciated for your Prompt Action!

x